TM 5-3815-226-13&P
LUBRICATION
ORDER
APPENDIX F
BUCKET, DRAGLINE 3/4 CU. YD MODEL DMD 34
REFERENCE: Manufacturers Commercial Manual
Hard time intervals and the related man hour times are
based on normal operation. The man-hour time
specified is the time you need to do all the services
prescribed for a particular interval. Change the hard time
interval if your lubricants are contaminated or if you are
operating the equipment under adverse operating
conditions, including longer-than- usual operating hours.
The hard time interval may be extended during periods
of low activity. If extended, adequate preservation
precautions must be taken.
WARNING
Dry cleaning fluid is flammable. Do not
use near a flame or excessive heat.
Use only with adequate ventilation.
Avoid prolonged breathing of vapors and
minimize skin contact.
*The time specified is the time required to perform all
services at the particular interval.
Clean parts or fittings with dry cleaning solvent (SD).
Type II or equivalent. Dry before lubricating. Dotted
arrow shafts indicate lubrication on both sides of
equipment. A dotted circle indicates a drain below.
Relubricate all items found
contaminated after fording or washing.
The lowest level of maintenance authorized to lubricate a
point is indicated by one of the following symbols as
appropriate: Operator/ Crew (C); and Organizational
Maintenance (0).
Reporting errors and recommending improvements. You
can help us improve this manual. If you find any
mistakes, or if you know of a way to improve the
procedures, please let us know. Mail your letter or DA
Form 2028 (Recommended Changes to Publications and
Blank Forms) direct to: Commander, US Army Tank-
Automotive Command, ATTN: AMSTA-MB, Warren, MI
48397-5000. A reply will be furnished to you.
*TOTAL MAN-HOURS
INTERVAL
MAN-HOURS
8
0.5
4
0.5
(SEE NOTE I)
*TOTAL MAN-HOURS
INTERVAL
MAN-HOURS
F-1
