TM 5-3815-225-13&P
APPENDIX F
LUBRICATION ORDER
BUCKET, CLAMSHELL, 3/4 CU. YD., MODEL 34GP S
REFERENCE: Manufacturers Commercial Manual
Hard time intervals and the related man-hour times are based on normal operation. The man-hour time specified is the
time you need to do all the services prescribed for a particular interval. Change the hard time interval if your lubricants are
contaminated or if you are operating the equipment under adverse operating conditions, including longer-than-usual
operating hours. The hard time interval may be ex- tended during periods of low activity. If extended, adequate
preservation precautions must be taken.
WARNING
Dry cleaning fluid is flammable. Do not use near a flame or excessive heat. Use
only with adequate ventilation. Avoid prolonged breathing of vapors and minimize
skin contact.
*The time specified is the time required to perform all services at the particular interval.
Clean parts or fittings with dry cleaning solvent (SD). Type II or equivalent. Dry before lubricating. Dotted arrow shafts
indicate lubrication on both sides of equipment. A dotted circle indicates a drain below. Relubricate all items found
contaminated after fording or washing.
The lowest level of maintenance authorized to lubricate a point is indicated by one of the following symbols as appropriate:
Operator/Crew (C); and Organizational Maintenance (O).
*TOTAL MAN-HOURS
INTERVAL
MAN-HOURS
8
0.5
4
0.5
(See NOTE 1)
NOTES:
1. Lube every 4 hours when used in water operations.
2. Lube at pivot points prior to operation and every 4 hours in water operations. (4-6 squirts).
3. LUBRICANTS. The following is a list of lubricants with military symbols and applicable specification
numbers:
OE/HDO MIL-L-2104
GAA MIL-G-10924
OEA MIL-L-46167
F-1
