• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Operator/Crew Preventive Maintenance Checks and Services - TM-5-3815-225-13P_71
APPENDIX B UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - TM-5-3815-225-13P_73

TM-5-3815-225-13P Bucket Clamshell Type II Size 70 3/4 Cu. Yd. General Purpose Intergy Model 34GPS Manual
Page Navigation
  10    11    12    13    14  15  16    17    18    19    20  
TM 5-3815-225-13&P APPENDIX B UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) GENERAL To  make  sure  that  your  equipment  is  ready  for  operation  at  all  times,  inspect  it  systematically  so  you  can  discover  any defects  and  have  them  corrected  before  they  result  in  serious  damage  or  failure.    The  charts  on  the  next  few  pages contain your unit PMCS.  The item numbers indicate the sequence of minimum ininspection requirements. If you’re operating the vehicle and notice something wrong which could damagethe    equipment    it    you    continue    operation,    stop operation immediately. Record all deficiencies  and  shortcomings,  along  with  the  corrective  action  taken,  on  DA  Form  2404.    The  Item  Number column is the source for the numbers used on the TM Number column on DA Form 2404. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES 1.  The item numbers of the table indicate the sequence of the PMCS.  Perform at the intervals shown below: a.  Do your (Q) PREVENTIVE MAINTENANCE quarterly.  (every three months). b.  Do your (S) PREVENTIVE MAINTENANCE semi-annually (every six months). 2.  If something doesn’t work, troubleshoot it according to the instructions in this manual or the commercial manual or notify your supervisor. 3.    Always  do  your  preventive  maintenance  In  the  same  order,  so  it  gets  to  be  a  habit.    Once  you’ve  had  some practice, you’ll spot anything wrong In a hurry. 4.  If anything looks wrong and you can’t fix it, write it down on your DA Form 2404.  If you find something seriously wrong, report it to direct support as soon as possible. WARNING Dry cleaning solvent P-D-680 Is toxic and flammable.  Wear protective goggles and gloves and use only In well ventilated areas.  Avoid contact with skin, eyes and clothes and don’t breath vapors.  Do not use near open flame or excessive heat.  The flash point Is 100 F - 138 F (38 C- 59 C).  If you become dizzy while using cleaning solvent, get fresh air Immediately and get medical aid.  If contact with eyes is made, wash your eyes with water and get medical aid immediately. WARNING Compressed air, used for cleaning purposes will not exceed 30 psi.  Use only with effective chip guarding and personnel protective  equipment  (goggles/shield/gloves, etc.). a.  Keep it clean: Dirt, grease, oil and debris only get in the way and may cover up a serious problem.  Clean as you work and as needed.  Use dry cleaning solvent (P-D-680) to clean metal surfaces.  Use soap and water when you clean rubber or plastic material. B-5







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.