DESCRIPTION (Column (6)). This column
quantity of the item used in the breakout shown on the
includes the following information:
illustration figure, which is prepared for a functional
group, subfunctional group, or an assembly. A "V"
(1) The Federal item name and, when required,
appearing in this column in lieu of a quantity indicates
a minimum description to identify the item.
that no specific quantity is applicable (e.g., shims,
(2) The physical security classification. Not
(3) Items that are included in kits and sets are
a. The "USABLE ON CODE" title appears in
listed below the name of the kit or set
the lower right corner of column (6), Description.
Usable on codes are shown in the right-hand margin
(4) Spare/repair parts that make up an assem-
of the description column. Uncoded items are applica-
bled item are listed immediately following the assem-
ble to all models. Identification of the usable on codes
bled item line entry. If the first item of a figure is
used in this publication are:
indented, the assembly appears as the last item in the
(5) NSN's for bulk materials are referenced in
the description column in the line item entry for the
item to be manufactured/fabricated.
Model AB1 HE
(6) When the part to be used differs between
Model A, 3/4 Cu. Yd.
serial numbers of the same model, the effective serial
numbers are shown as the last line of the description.
Model 2- 75
(7) The USABLE ON CODE. When applicable
(see paragraph 4, Special Information).
Model DLM 34G
(8) In the Special Tools List section, the Basis
b. Bulk materials required to manufacture
Of Issue (BOI) appears as the last line(s) in the entry
items are listed in the Bulk Material Group of this
for each special tool, special TMDE, and other special
manual. NSN's for bulk materials are also referenced
support equipment. When density of equipments
in the description column of the line item entry for the
supported exceeds density spread indicated in the
item to be manufactured/fabricated. Detailed manu-
basis of issue, the total authorization is increased
facturing instructions for items source coded to be
manufactured or fabricated are found in TM5-3815-
U/M (Column (7)). The Unit of Measure
(U/M) indicates the measure (e.g., foot, gallon, pound)
c. Detailed assembly instructions for items
or count (e.g., each, dozen, gross) of a listed item. A
source coded to be assembled from component
two-character alpha code (e.g., FT, GL, LB, EA, DZ,
spare/repair parts are found in TM5-3815-200-23.
GR) appears in this column to indicate the measure
Items that make up the assembly are listed immedi-
or count. If the U/M code appearing in this column
ately following the assembled item entry.
differs from the Unit of Issue (U/I) code listed in the
Army Master Data File (AMDF), request the lowest U/I
d. Line item entries for repair parts kits and sets
that will satisfy your needs.
appear as the last entries in the repair parts listing for
the figure in which their parts are listed as repair parts.
QTY INC IN UNIT (Column (8)). The Quantity
Incorporated in Unit (QTY INC IN UNIT) indicates the